Using, maintenance and precautions of cut-resistant gloves
Source:HuanyuAuthor:Gloves Addtime:2019-04-17 10:26:25 Click:
When choose anti-cutting gloves
as risk-prevention measure, users should understand limitation and care of gloves when using them in addition to material, application and price, which can be found in the instruction or label of gloves.
Firstly, different cutting-proof grades and performance for different workplaces. For example, it is not advisable to use single metal anti-cutting glove when recycling medical waste or handling glass shards,. Because anti-cutting glove is made of steel wire, there are many dense holes can be penetrated by sharp objects. At this time, the BLADE X5 series of dipped anti-cutting and puncture-proof gloves can be selected for double protection. Another example, when it comes to food industry, light assembly work, assembly of automotive parts and electrical accessories, it is most suitable to use BLADE X5 fiber and Lycra knitted gloves. This glove can be used alone or as protective liner for other gloves. .
Secondly, the size of glove should be appropriate. On one hand, the size is too small to wear uncomfortable, and restricting blood circulation is easy to cause fatigue. On the other hand, the operation is not flexible and it is easy to fall off if the size is too large. Gloves should also be used with adequate protection. For environments where high-grade cut-resistant gloves
should be used, low-grade anti-cutting glove can not be selected, in contrast, eliminating the need for high-grade cut-resistant gloves in using environment where only general cutting-proof gloves are required. These data all can be found in the user` s guide of glove. For example, in actual operation, the cut-proof gloves are not completely cut-proof, only for manually operated tools, and knitted fiber gloves are not resistant to sawtooth or wave cutting edges.
Cleaning. Use industrial detergent soap or detergent (do not use chemical cleaner and bleach), wash with warm water, water temperature does not exceed 50 ° C and washing time is about 5 min, warm water bleaching. It is recommended to soak for 10 min firstly if the dirt is particularly heavy, then wash and bleach repeatedly, finally, bleach with cold water, roll and dry, and dry again under the sun.
Care. Good storage environment can increase the service life of anti-cutting gloves, it is recommended to store gloves in dry and dark environment with room temperature. For work gloves
with special functions, such as electrical insulating gloves, product should be tested before use to ensure the effect. Please wash with appropriate solvent when there are a lot of chemical residues, but avoid using corrosive cleaning solution and dry it thoroughly after washing.
It is not advisable to use cut-proof gloves in life or when sanitation workers repair barbed flowers. Because the cut-resistant gloves are made up of steel wires, there are many dense holes that allow thorns to pass through. Cut-proof gloves are designed for long-term industrial safety. In long-term use, gloves will inevitably have small holes because of frequent contacting with sharp weapon, it may threaten the safety of users If holes of glove are too large, then gloves need to be repaired or replaced at this time.